10 Seat Keys Replacement Tricks All Pros Recommend
Seat Alhambra Key Problems
Seat's jumbo MPV range is among the top models in its class when it comes down to resale value. With a brand new model on sale, the family MPV jumbo is more impressive.
There are a myriad of reasons the key fob might not function properly, such as an inoperative coin battery water damage to the receiver module, or signal interference. This article will walk you through the steps to fix it.
Water Damage
If your key fob for the seat alhambra withstands washing cycles or a dip in an ocean or a pool, then it's got a waterproof chip. However, don't do it often since prolonged exposure to water increases the chance that the key fob will be damaged. If the key fob ceases to working after exposure to clean water from the tap or rain, then just remove the battery, wipe the electronic component with a towel and let it dry completely before putting the battery back into. If the battery is exposed to soapy water or salt, it is recommended that you clean the chip using isopropyl alcohol or a electronic cleaner prior to attempting to insert the battery back in.
Faulty Receiver Module
If the key fob will not lock or unlock even after you've replaced the battery for the button it is possible that the receiver module has a fault. It is a relatively easy and inexpensive fix. You can disconnect the 12 volts battery for a couple of minutes (first take off the negative cable, then press the horn a few times) to drain any remaining electricity. Then connect it in reverse. positive cable first then negative cable later.
ESP Warning Light If the ESP warning light flashes, this is normal and means that the car is driving over terrain where the traction of the road surface and tyres aren't as good, such as gravel, snow or a lot of surface water. If the ESP light is constantly on, it means that there is a fault in the system. It can be detected by using an iCarsoft i908 seat OBD code reader kit. It will provide you with a detailed information about the fault.
Dead Coin Battery
One of the most frequent reasons for the seat alhambra key to stop working is a dead coin battery. The key fob comes with a small button cell battery that is able to keep it powered. It should be replaced by a new battery that has exactly the same size, voltage, and specification as the original. When replacing the battery on the key fob remove all metal clips and ensure that the contacts of the key fob are clean and corrosion-free.
If the key fob was exposed to water (such as soapy tap water) it is recommended to remove and clean the chip with an electronic cleaner or isopropyl alcohol prior to installing a new battery. The chip can be permanently damaged by moisture. If the key fob still isn't working after replacing the battery it could be necessary to replace the key fob.
Faulty Receiver Module
If your key fob stopped working after you replaced the battery, but it did not help, or if it stopped working completely suddenly the receiver module might have developed a fault. The receiver module takes the radio frequency signals from your remote keyfob and transforms them into electrical signals that are then processed by other modules within the car.
If the receiver module has developed a fault it will not respond to any of the commands transmitted by your remote key fob. In this instance, you will need to visit a dealer to reprogramme the key fob, and also a new receiver module.
The key fob has been sealed with rubber to prevent water from getting into the electronic chip. If you submerge the key fob in salted or soapy water it could cause damage to the chip. You can try cleaning the chip by rub it with isopropyl alcohol or electronic cleaner, but If your key fob doesn't work after doing this, then you'll need to purchase a new one.
If the keys are successfully paired, but your receiver module isn't working then you can restart all the electronics in the board by disconnecting the battery that is 12 volts for a couple of minutes. Then reconnect the battery in reverse order (negative cable first and then positive). seat replacement key will reset all the on-board electronics and should bring them back into operation.
Electronic Chip Faulty
The key fob is equipped with tiny electronic chips that sends a signal to the receiver module whenever the key is used. If the signal doesn't match the one the car has stored, the immobilizer will disable and stop the car from starting. However, if the fob isn't functioning and you are not able to reprogram it, it could be due a damaged chip.
The chip inside the key fob isn't an indefinite part of the device, and might need to be replaced in order to get it to work again. This can be accomplished by taking the key fob away from its case, and using a needle or pin to touch each metal clip. You will have to replace them in the event of damage or corrosion-prone. Make sure that any replacement batteries are of the same size, voltage and specifications as the original.
The Seat Alhambra is a popular and well-designed car however, just like any other vehicle, it can sometimes experience issues with specific parts or equipment. For example, some owners have experienced problems with the climate control system, which may become faulty and stuck in a particular setting. The infotainment system may also fail and freeze the screens.